110V Installation

Open box with the 110V transformer located in the
GlowingSeas packaging.

Locate the wire on the GlowingSeas light, one is marked with
white writing (Tracer). This will be the POSITIVE Lead (+)

PRIOR to plugging in the transformer into an outlet, on the
back of the transformer, there are two screw terminals, unscrew both screws,
and place the wires from the GlowingSeas light underneath then tighten. The one
with the white tracer should be under the positive (+) lead.

Once tightened, plug in the transformer into an outlet, we
recommend an outdoor outlet that is protected with a GFCI circuit.

Cycle through the settings until the green light is located
in the ON position, light should illuminate

12V Installation

Simply attach alligator clips to any 12V battery source with
the red lead on the positive post. DO NOT connect to higher voltage then 12V or
the light will be damaged.

Lights will float intentionally, we recommend attaching a
length of monofilament to the collar on the light with a weight to keep it off
the bottom, we also recommend the light be placed out of boat and marine
traffic to avoid propellor damage which is not covered by warrantee. The ideal
depth of the light for maximum brightness is 18-24” below the water.